Tsukineko, Tack ’n Peel clear sheet is a unique, reusable product designed for creating a stamping block when using unmounted stamps. RETAIL $9.95. This transparent Tack ’n Peel allows for easy aligning of your unmounted stamps on acrylic blocks. Simply rinsing the surface with water and air-drying can easily preserve the adhesive layer – stickiness will restore over and over again so you only need to purchase one for all of your unmounted stamps. Economical and a super space saver. Tack ’n Peel clear sheet can be used on acrylic or wood blocks, however, its unique feature allows for any either flat or curved surface to also become a stamping handle. Sheet measures 4" X 6 1/2" x 1/16". Make sure to check http://www.tsukineko.com/new2.php for Instructions, helpful hints and samples. It's a great link to see the uses of the Tack 'n Peel, and will show you how to create a custom stamp out of any object. Instructions below are copied from this link. INSTRUCTIONS 1. Place block on the yellow side of the Tack ’n Peel sheet and trace the outline with a thin permanent marker. 2. Use scissors or craft knife to cut out the traced shape. 3. Peel off the yellow liner from the Tack ‘n Peel and place onto the block or handle. 4. Remove the clear liner but do not discard. 5. Place your unmounted stamp or any found object onto exposed side and begin your stamping project! 6. When finished, remove the stamp or design object and replace the saved clear liner to protect the surface until ready to use again. (Caution, unmounted stamp or design object should be removed for proper storage to prevent difficulty in removing later.) 7. When ready for re-use, restore tackiness by just wiping the surface with a wet cloth or rinse with water if needed, and allow to air dry. Retail Value $9.95